audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Customer Interest:|691013|Page 1054 > < Computers/Control - No Start After CAN Bus Silence|Page 1047
Page 1
background image

Air Bag Control Module: Customer Interest
Restraints - Can't Code Replacement Air Bag Control Unit

69 Replaced airbag control unit cannot be coded

69 10 13 

2023323/5 

November 4, 2010. 

Supersedes Technical Service Bulletin Group 69 number 10-10 dated September 10, 2010 for reasons listed below.

Affected Vehicles

Condition
After replacing the airbag control unit, the control unit cannot be coded via SVM spec/actual.

TECHNICAL BACKGROUND

The latest revision of the airbag control unit must be coded and parameterized using an SVM code, which is listed in ETKA in the remarks area for the
part number. This information can only be seen when performing an FI Search (VIN specific search) within ETKA.

PRODUCTION SOLUTION

Not applicable

Customer Interest:|691013|Page 1054 > < Computers/Control - No Start After CAN Bus Silence|Page 1047