A6 V6-3.0L (AVK) (2004)
Glove Compartment Lock: Service and Repair
Glove Box Lock, Removing And Installing
-
Remove glove box lid
-
Remove screw - 1 - (4x).
Tightening torque: 1 Nm (9 in.lb)
-
Use screwdriver to pry open glove box lid - 3 - slightly on inside (at arrow -A-).
-
Pull trim panel - 2 - approx. 15 mm out of retainers - 4 - (3x) in direction of arrow - A -.
-
Lift trim panel - 2 - approx. 15 mm and detach trim panel - 2 - from glove box lid - 3 -.
-
Use screwdriver - 2 - to pry off glove box opening mechanism - 1 - on left and right in direction of arrow.
-
Remove glove box opening mechanism - 1 -.
-
Use screwdriver - 3 - to pry bracket - 2 - on left and right side out of glove box opening mechanism - 1 - in direction of arrow.
NOTE: Lock cylinder can only be removed with key inserted.
Removing