A6 V6-3.0L (AVK) (2004)
/Page-4280002.png)
-
Insert ABS wheel speed sensor -1- until stop.
-
Locating tab -A- faces front on left and rear on right.
-
Push ABS wheel speed sensor into wheel bearing housing by hand.
-
Insert retainer for ABS wheel speed sensor.
Note: When routing the ABS wheel speed sensor wiring note the following:
-
Route ABS wheel speed sensor wiring -1- next to brake line -2- on both sides as shown.
-
On the left side, maintain a clearance of about 2 cm between the heat shield on the exhaust system and ABS wheel speed sensor wiring.
-
On right-hand side, ABS wheel speed sensor wire -1- must be routed between fuel lines -2-.
