A6 V6-3.0L (AVK) (2004)
-
Specified value: Wire resistance max 1.5 Ohms
-
Also check wires for short circuit to each other as well as to B+ and Ground (GND).
-
Specified value: Infinity Ohms (no continuity)
-
If necessary, repair wire connection.
If no malfunctions are found in wires:
-
Replace Engine Control Module (ECM).
If no malfunctions are detected:
-
Replace mechanical camshaft adjuster.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1
-
Check DTC memory, Diagnostic mode 3 - Check DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 3: Check DTC Memory
2
-
Erase DTC memory, diagnostic mode 4 - Reset/erase diagnostic data. See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic
Data
3
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes/Audi Drive Cycle/Readiness Code/With Generic Scan Tool/Readiness Code, Generating
-
End diagnosis and switch ignition off.