A6 V6-3.0L (AVK) (2004)
-
Remove bolts -1- and -2-.
-
Remove front sealing flange.
-
Drive out sealing ring with the flange removed.
Note: Remove chain tensioner to replace sealing flange, Refer to Oil Pump, Service and Repair.
Installing
Installation is reverse of removal, noting the following:
Note: Always replace seals, sealing rings and self locking bolts.
-
Clean sealing surfaces before installing sealing flange.
-
Install front sealing flange with secured chain tensioner.
-
Replace bolt -2-.
-
Tighten bolts -1- to 10 Nm and bolt -2- to 30 Nm.
-
Do not oil sealing lip or outer edge of sealing ring before pressing in.
-
Slide on sealing ring using 3202/1 pull sleeve.
-
Press in sealing ring with 3265 seal installer and central bolt up to stop.