A6 V6-3.0L (AVK) (2004)
8
Seal
-
replace
-
to install, place into opening of fuel tank when dry
9
Fuel Level Sensor 2 -G169-
-
Drain fuel tank before removing
10
Suction jet pump
-
With lines
-
secured to fuel level sensor 2
Part II
Component Locations, Overview
1
Union piece
-
Clipped in on baffle housing with 3 catches
-
To remove, press toward left so that catches disengage and lift upward Insert fuel line into baffle housing when installing
-
To remove the Fuel Pump (FP), union piece must be unclipped so that fuel return line (from connector flange) can be disconnected
2
Baffle housing lower part
-
With suction jet pump
3
Electrical wire
-
to Fuel Level Sensor 2 -G169-
-
Connect on connector flange
4
Electrical wire
-
To Sender for fuel gauge -G-
-
Connect on connector flange
5
Harness connector
-
for Fuel Pump (FP) and all senders for fuel gauge
-
Releasing, See Fig. 1
6
Fuel return line
-
Clipped in on front at fuel tank
-
Mark before removing
7
Fuel supply line