A6 V6-3.0L (AVK) (2004)
8
Union nut -80 Nm
-
Use ring nut spanner 3217 to remove and install
9
Harness connector
-
for Fuel Pump (FP) and sender for fuel gauge -G- Releasing Fig. 1
10
O-Rings
-
replace
-
Check installation position
11
Return line
-
Disconnect from connector flange to remove fuel tank
12
Baffle housing lower part
-
With suction jet pump
-
Fuel tank not depicted in illustration
Fig. 1 Releasing harness connector
-
To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a
small screwdriver -arrow-.