A6 V6-3.0L (AVK) (2004)
-
Check the following wire connections for open circuit according to wiring diagram:
Harness connector
Test box
Terminal
Socket
1
72
2
73
3
36
4
35
5
33
6
34
-
Specified value: Wire resistance max 1.5 Ohms
-
Also check wires for short circuit to each other, to B+ and Ground (GND).
-
Specified value: Infinity Ohms (no continuity)
-
If necessary, repair wire connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace accelerator pedal module.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1
-
Check DTC memory, Diagnostic mode 3 - Check DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool
Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 3: Check DTC Memory
2
-
Erase DTC memory, diagnostic mode 4 - Reset/erase diagnostic data. See: Computers and Control Systems/Testing and Inspection/Scan Tool
Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
3
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes/Audi Drive Cycle/Readiness Code/With Generic Scan Tool/Readiness Code, Generating
-
End diagnosis and switch ignition off.