A6 V6-3.0L (AVK) (2004)
-
To fuel filter
-
Clipped in on front at fuel tank
-
Mark before removing
8
Locking ring
-
Use ring nut spanner 3087 to remove and install
-
Tighten to 120 Nm
9
Seal
-
replace
-
to install, place into opening of fuel tank when dry
10
Connector flange
-
For Fuel Pump (FP)
-
not individually replaceable
-
Installation position: Note arrow marking
11
Fuel pump
-
Can be replaced only complete with connector flange
-
Check Fuel Pump (FP) electrically
-
Checking delivery quantity
-
Checking residual pressure
12
O-Rings
-
replace
-
Check installation position
13
Fuel return line
-
To remove the Fuel Pump (FP), unclip union piece and disconnect fuel return line at union piece -item 1-, press release button to do so
14
Fuel screen
-
not individually replaceable
-
Clean if soiled
Fig. 1 Releasing harness connector
-
To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a
small screwdriver -arrow-.