A6 V6-3.0L (AVK) (2004)
/Page-4657002.png)
^
Guide wire through openings in wheel bearing housing and remove.
Do not damage rubber grommet!
^
Unscrew hex bolt -3- and nut -4-.
^
Pull out be rod end.
^
Unscrew nut from joint bolt.
Use 4 mm socket wrench to hold joint bolt if necessary.
^
Press joint bolts of guide link off conical seating.
Be careful not to damage CV boot in the process!
For vehicles with headlight vertical aim control, refer to Vehicle Level Sensor.
Note:
^
Protect CV boot from damage, e.g.: place a leather cloth in between.
^
For safety reasons, put collar nut back on joint bolt of track control link with about 4 turns.
^
Press joint bolts of track control link off conical seating.
