A6 V6-3.0L (AVK) (2004)
/Page-4856002.png)
^
Pressing out 75 mm dia. refer to Fig. 1
^
Pressing out 82 mm dia. refer to Fig. 2
^
Pressing in 75 mm dia. refer to Fig. 5
^
Pressing in 82 mm dia. refer to Fig. 6
^
Pressing off bearing inner race refer to Fig. 3
^
Removing and installing with wheel bearing housing installed
13. Heat shield
14. Lower control arm
15. Front bonded rubber bushing for lower control arm
^
Pressing the bushing out is extremely difficult or impossible, if it is pressed in very tight. Therefore, we recommend replacing the entire control
arm if a bonded rubber bushing requires replacement.
16. Rear bonded rubber bushing for lower control arm
17. Hex bolt, 55 Nm
18. Drive axle
19. Front bonded rubber bushing for upper control arm
^
New bushing does not have kidney-shaped recess
20. Backing plate
21. Socket-head bolt
^
Tightening torques:
Bolt M8 X 48: 40 Nm
Bolt M10 X 48: 70 Nm
22. Upper control arm
23. Rear bonded rubber bushing for upper control arm
^
Pressing out and pressing in
^
New bushing does not have kidney-shaped recess
24. Hex bolt M12 x 1.5 x 95
^
70 Nm plus additional 90° turn
^
Always replace after disassembly
25. Washer
26. Self-locking nut
^
Always replace after disassembly
27. Coupling link
^
Installation position: curved part faces outward
28. Screw and washer assembly with ribbed washer
^
70 Nm plus additional 90° turn
^
Only use this special bolt as replacement!
