A6 V6-3.0L (AVK) (2004)
^
Unscrew bolt-3- for shock absorber at lower control arm.
1. Control arm
2. Parking brake cable
3. Bolt for shock absorber
A - Holding clip for parking brake cable
^
Pull wheel bearing housing downward along with lower control arm.
^
Now push a drift -1- or something similar through hole of shock absorber bushing.
^
Unscrew lower hex bolt for coupling rod.
Installing
Installation is reverse of removal.
Tightening torques:
Shock absorber to control arm ....................................................................................................................................................................... 70 Nm + 90°
Always use new bolts.
Coupling rod to wheel bearing housing ................................................................................................................................................................... 55 Nm
Coupling rod to stabilizer ........................................................................................................................................................................................ 50 Nm
Stabilizer bar clamp to axle beam ........................................................................................................................................................................... 25 Nm
Brake caliper to wheel bearing housing ......................................................................................................................................................... 70 Nm + 90°