A6 V6-3.0L (AVK) (2004)
/Page-4904002.png)
^
The vehicle level sensor has been replaced;
^
The retaining clip for coupling rod on link has been loosened.
Basic setting of the headlights
1. Bracket
2. Left Front Level Control System Sensor -G78-
^
Checked electrically via On Board Diagnostic (OBD)
^
For problems/complaints
3. Socket head bolt, 10 Nm
4. Rivet
5. Self-locking nut, 10 Nm
^
Always replace after disassembly
6. Suspension strut
7. Coupling for stabilizer bar
8. Actuating arm of Left Front Level Control System Sensor -G78-
^
Do not remove coupling link from ball head!
^
Coupling rods must not be swapped for Allroad
9. Position marks on control arm for installation position of left front level control system sensor G78-
10. Front link, lower
11. Clip
^
Pry out with a slotted-head screwdriver, for example
When removing and reinstalling track control link it is necessary to remove metal clip.
Note: When installing linkage to the level sensor, use a 10 mm open-end wrench with dimension -A- = 4 mm to avoid damaging the seal.
^
Dimension -A- 4 mm
^
Wheel bolt tightening torque: 120 Nm
^
The linkage for the headlight vertical aim control is fastened to the track control link between the stops using pliers.
When installing headlight vertical aim control, make sure that the sensor crank and linkage are in correct orientation to one another.
Note:
^
Linkage must be vertical.
^
The crank sensor (arm) must point forward and downward.
^
Coupling rods must not be swapped with each other for Allroad.
Level sensor in Installation position - Allroad
