A6 V6-3.0L (AVK) (2004)
Suspension Spring ( Coil / Leaf ): Service and Repair
Shock Absorbers (Front Wheel Drive), Servicing
Shock absorbers/springs, removing and installing
Special tools and equipment
^
VAG1383 A engine/transmission jack
Removing
Note: To remove and install springs and shock absorbers, use engine/transmission jack VAG1383 with holder 135912.
^
Raise vehicle to installation height, taking tension off coil springs.
^
Remove bolt -2- on left and right, and lower engine and transmission jack.
^
Pull down rear axle, by second mechanic if necessary, and remove coil spring.
^
Unscrew bolt -1 - and remove shock absorber.
Installing
Installation is reverse of removal.
^
Replace all bolts and nuts.
^
Insert shock absorber in body and tighten to 45 Nm.
^
Pull down rear axle, by second mechanic if necessary, and install coil spring. Note installation position, item no. 4