A6 V6-3.0L (AVK) (2004)
/Page-4975003.png)
^
Pull out wheel hub while holding device securely.
1. 17/2 Kukko separating tool
2. Bell E-40
3. Hollow piston cylinder H KZ-1 5
4. Special nut E-8-214 and be bolt
5. High pressure hose with quick-release
Pulling out wheel bearing
^
Attach pressure piece -1- with collar to bearing, pressure sleeve -2with four stepped inside diameters to wheel bearing housing, hollow piston
cylinder -3- with tie bolt, and special nut -4-.
^
Pull out wheel bearing by actuating pump.
1. Pressure piece E-5
2. Pressure sleeve E-44-1
3. Hollow piston cylinder H KZ-1 5
4. Special nut E-8-214 and tie bolt
Pull bearing inner race off hub
^
Attach separator -1- behind bearing inner ring -2-.
Installation position: Beveled part of blades faces bearing inner ring.
^
Put on bell -3- and hollow piston cylinder -4- with tie bolt, screw on with special nut -5-, and pull off bearing inner ring.
1. 17/2 Kukko separating tool
2. Bearing inner ring
3. Bell E-40
4. Hollow piston cylinder H KZ-1 5
5. Special nut E-8-214 and be bolt
Pressing in wheel bearing
Installation position: Large inside diameter of wheel bearing faces out.
