A6 V6-3.0L (AVK) (2004)
/Page-3149002.png)
13. Starter Inhibitor relay -J207-
^
Location; Refer to Fig. 16,
14. Selector lever position display -YS-
^
Location; Refer to Fig. 17
15. Kick down switch -F8-
^
Location; Refer to Fig. 18
16. Brake light switch -F-
^
Location; Refer to Fig. 19
Fig. 21 Removing automatic transmission control module -J217-
Removing
^
Removing lower right A-pillar trim and right door sill trim piece.
^
Detach carpeting from inside of sill (right-side) below front door, and raise carpeting approximately 20 cm.
^
Unclip box at -A- by pulling it upward.
^
Unclip box at -B- as shown.
^
Unclip TCM from box (arrows).
^
Release catch on multi-pin connector and disconnect connector from TCM; Refer to Fig. 22
Installing:
Installation is the reverse of removal, with the following additional steps:
^
Check that clip -1- is properly secured:
