A6 V6-3.0L (AVK) (2004)
/Page-3258002.png)
^
Disconnect battery ground connection.
^
Remove handle for selector lever; Refer to Fig.
^
Remove front center console.
^
Remove steering wheel.
^
Turn ignition key to driving position (ignition on).
^
Shift selector lever to "P".
^
Lift clip for retainer -1- and pull out lock cable from ignition/starter switch.
^
Remove cover with gate (selector lever actuation).
^
Unclip lock cable from securing spring at mounting bracket while slightly lifting securing spring; Refer to Fig. 8.
^
Free lock cable from cable be -2- and remove.
Installing
^
Route lock cable without kinks.
^
Turn ignition key to driving position (ignition on).
^
Insert lock cable in ignition/starter switch.
^
Check locking device -1- for proper engagement.
^
Attach lock cable with cable tie -2- to airbag sensor.
^
Turn ignition/starter key to lock position (ignition Off).
^
Shift selector lever to "P".
^
Clip in lock cable in securing spring of mounting bracket; Refer to Fig. 8.
^
Insert lock cable bracket -3- in shift mechanism and lock cable eye in lever for lock cable.
Adjusting
^
Shift selector lever to "P".
^
Loosen bolt -6-.
^
Clamp -3- must be movable by hand in direction of arrow -5-.
^
Move steering column to lowest position.
^
Insert gage 3352 A -item 4- between lever for lock cable and lock cable eye.
^
Pull lock cable in direction of arrow -5- and tighten bolt -6- with 10 Nm (7 ft. lbs.).
^
Remove adjustment gage.
^
Check ignition key removal lock after every adjustment of the lock cable.
^
Install steering wheel.
^
Install front center console
^
Install handle for selector lever; Refer to Fig.
See Caution for connecting Telematics battery
^
Reconnect battery ground cable.
^
For vehicles with theft-protected radio reactivate code.
