A6 V6-3.0L (AVK) (2004)
/Page-3353003.png)
^
Remove securing bolts -arrows- of valve body and remove valve body with wiring harness.
Notes:
^
Only loosen the indicated bolts (arrows).
^
If other bolts are loosened, the operation of the valve body may be affected or the valve body may become separated.
^
The bolt (arrow -A-) is shorter than the other bolts. Observe allocation.
All
^
Remove valve body from transmission while guiding wiring harness connector.
Note for transmissions with hydraulic control E17: Do not set removed valve body on sensor for transmission RPM at rear of valve body. Risk
of damage.
Installing
^
Lightly coat O-ring of wiring harness connector with ATF.
^
Insert wiring harness connector into transmission housing.
^
Installation position: Flat part of rear shoulder points downward, the tabs at shoulder are horizontal.
Only for transmissions with hydraulic control E18/2
^
Route wire with connector -C- according to illustration so that the wiring is not pinched during installation of the valve body.
All
