A6 V6-3.0L (AVK) (2004)
^
Press remaining amount of grease into CV boot.
^
Make sure boot is properly seated on joint piece.
^
Boot must make contact in the groove and the contour of the joint piece
^
Position joint piece in center position. See min - max position
Note: Vent CV boot e.g. using a screwdriver, while positioning joint piece in center position (arrow)
^
Mount clamp. Refer to Fig. 5
Note: Position the crimping tab -2- of the clamp between mounting flanges -1- of joint piece. This will facilitate threading the socket head bolts
during installation of the drive axle
^
Tighten small clamp using VAG1275 pliers.