A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
/Page-6006002.png)
14. Stop buffer
^
Clip into cable lever -16-
^
Install with large contact surface toward selector lever
15. Detent
^
Clip into cable lever -16-
16. Cable lever
^
Secured in mounting bracket -21- with fulcrum pin -22-
17. Spring clip with roller
^
For gearshift positions
18. Spring clip with roller
^
For Tiptronic position
19. Frame
^
Clip onto mounting bracket
^
Install with ribbed side upward
20. Nut
^
10 Nm (7 ft. lbs.)
21. Mounting bracket
22. Fulcrum pin
^
Secures cable lever -16- in mounting bracket -21-
23. Locking pawl
^
For shift lock
24. Shift lock solenoid -N110-
^
Can be checked via electrical testing and reading measuring value block
25. Fulcrum pin
^
For locking pawl
26. Cover
^
With seal for mounting bracket
27. Nut
^
10 Nm (7 ft. lbs.)
28. Securing clip
^
Secures selector lever cable to cable lever -16-
^
Install with angled end forward
29. Locking plate
^
Secures selector lever cable to mounting bracket
^
Install with angled end toward inside of mounting bracket
30. Selector lever cable
^
Do not bend or kink; lightly grease cable eye and ball socket before installing.
^
Selector lever cable must be replaced if rubber sleeves are damaged
^
When installing, make sure that rubber sleeve on transmission side is not twisted
31. Hex bolt
^
23 Nm (17 ft. lbs.)
32. Support bracket
^
For mounting selector lever cable on transmission
^
Removing and installing
33. Cable tie
^
For lock cable
34. Ignition/starter switch
35. Lock cable
^
For ignition key removal lock
^
Must not be kinked
36. Locking lever
37. Securing spring
38. Mount
