A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
/Page-6157005.png)
Notes:
^
Radial run-out must always be measured if the flange drive shaft rear final drive was removed. Make new color marking and remove old color
marking.
^
If a new drive shaft is installed and the color marking on the drive flange of the rear final drive is no longer visible, location of largest radial
run-out must be determined and marked with a color marking.
^
Align this colored dot with colored dot on drive shaft.
^
Radial run-out can also be measured with the rear final drive installed, however the drive shaft must be disconnected from the rear final drive.
See notes.
-
Attach VW387 dial gauge holder with dial indicator to connection between crossmember and final drive.
-
Set dial indicator onto ground diameter -arrow- in drive shaft flange and set to "0" with 1 mm preload.
-
Turn differential via both rear wheels (right and left drive flanges) in one direction until the drive shaft flange has made one complete revolution
-
Mark largest radial run-out on outer edge of flange with colored marking (equivalent to largest distance from turning axis).
-
Remove old marking on drive shaft flange.
-
Installing drive shaft.
Driveshaft, adjusting
Special tools and equipment
^
Assembly stand 3213
