A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
/Page-6189002.png)
^
Paired with synchrohub
^
Mark before removing
8. Circlip
^
Redetermine thickness when replacing synchrohub see Fig. 3
^
Installation position: ends align with groove of synchrohub
9. Synchrohub for 3rd and 4th gear
^
Pressing off see Fig. 4
^
Installation position see Fig. 5
^
Pressing on see Fig. 6
10. Synchroring for 3rd gear
^
Coated with molybdenum
^
Check for wear see Fig. 2
11. 3rd speed sliding gear
^
Before installing, insert spring see Fig. 1
^
After pressing on -item 9-, check axial clearance with a feeler gauge (0.15 - 0.35 mm)
12. Needle bearing for 3rd gear
^
Mark before removing
^
Do not interchange with needle bearing for 4th gear
^
Oil with gear oil before installing
13. Input shaft
14. Spring pin
^
Drive in when replacing input shaft see Fig. 7
15. Bearing plate
^
Servicing
16. Inner race for cylinder roller bearing
^
Take off and fit by hand
17. Circlip
18. Thrust washer for needle bearing for 6th gear
^
Installation position: shoulder towards circlip, smooth contact surface towards needle bearing
19. Needle bearing for 6th gear
^
Oil with gear oil before installing
20. 6th speed sliding gear
^
Before installing, insert spring see Fig. 1
^
After installing, check axial clearance with a feeler gauge (0.15 - 0.35 mm)
21. Synchroring for 6th gear
^
Check for wear see Fig. 2
22. Synchro hub for 5th and 6th gear
^
Pulling off
^
Driving on
^
Installation position: projecting hub towards 5th speed sliding gear
23. Locking collar
^
Paired with synchrohub
^
Mark before removing
24. Synchroring for 5th gear
^
Checking for wear see Fig. 2
25. 5th speed sliding gear
^
Before installing, insert spring see Fig. 1
^
After installing, check axial clearance
26. Inner race for 5th speed sliding gear
^
Pulling off
^
Driving on
27. Needle bearing for 5th gear
^
Oil with gear oil before installing
28. 1st inner race for tapered roller bearing for input shaft
^
Pulling off
^
Driving on
29. End cover
^
Servicing
30. 2nd inner race for tapered roller bearing for input shaft
^
Pulling off
^
Driving on
31. Loosening and tightening
