A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
/Page-6118005.png)
-
Pulling small tapered roller bearing outer race into housing.
-
The outer race must be oiled and installed using VW408A punch and 30-205 thrust pad.
-
Install drive pinion without spacer sleeve.
-
Heat tapered roller bearing inner race to 100°C and install on drive pinion.
CAUTION: Wear protective gloves.
Notes:
-
Do not grease new tapered roller bearings additionally for friction torque measurement. The bearings are already greased with a special oil from
the factory.
-
Only install spacer sleeve if friction torque has been adjusted (Shim S3 already determined).
A - Standard torque gauge, 0- 600 Ncm
B - 36 mm socket insert
Note: If necessary use 3/4" to 1/2" adapter.
