A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
-
Press outer race for taper roller bearing without shim "S1" into cover for differential.
-
Insert differential without drive wheel for speedometer sender -G22- into transmission housing. The ring gear is positioned on the left-hand side
(same side as cover for final drive).
-
Install cover for differential with 4 bolts (25 Nm).
-
Position transmission so that the cover for differential faces up.
-
Turn differential 5 turns in both directions so that the taper roller bearings settle.
-
Assemble measuring equipment, use a 30 mm dial gauge extension.
-
Set dial gauge (3 mm measuring range) -A- to "0" with 2mm preload.
Note: The tip of the dial gauge must be positioned on center of differential.
-
Lift differential, without turning, and read off play on dial gauge.
^
Measurement in following example: 0.62 mm.