A6 Quattro Sedan V6-2.7L Turbo (APB) (2000)
-
Pull out seal.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Replace O-ring between drive pinion bearing and flange.
-
Lightly oil O-ring before installing.
-
Lightly oil outer circumference of seal.
-
Drive in seal for driveshaft flange onto stop with drift 3026.
-
Fill space between sealing and dust lips with a thin layer of G 052 128 A1 sealant.
-
Drive driveshaft flange onto drive pinion until retaining nut can be fitted.
-
Clean drive pinion nut and threads on drive pinion of oil and grease residues. Thinly coat threads with locking fluid D 000 600.
Note: Use the originally fitted hexagon nut to secure the flange on the drive pinion, otherwise it will not be possible to reproduce the original
installation position.