A6 Quattro Sedan V6-2.8L (AFC) (1995)
17. Remove A/C and heater control unit knobs.
18. Remove two attaching screws, then the A/C and heater control trim plate.
19. Remove ash tray attaching screws, then the ash tray.
20. Loosen two screws at rear of front center console, then lift front center console upward.
21. Disconnect electrical connectors, then remove center console from vehicle.
22. Remove control module retaining nuts, Fig. 14.
23. Disconnect triggering unit electrical connector, then remove triggering unit.
24. Reverse procedure to install. Tighten control module retaining nuts to specifications.