A6 Quattro Sedan V6-2.8L (AFC) (1995)
Child Seat Tether Attachment: Service and Repair
Child Restraint Anchorage, Installing
Child Restraint Anchorage, Assembly (Rear Seat - Sedan Only)
-
Remove rear seat bench, seatback.
-
Open rear lid.
-
From inside trunk locate anchorage points for washer 7, pop-rivets 6 in rear filler panel sheet metal.
-
Points in line between rear speakers
-
Mark center of anchor point hole on rear of filler panel trim.
-
Remove rear filler trim panel.
-
Drill a 8.0 mm (5/16 in.) starter hole in rear filler trim panel at center mark.
-
Enlarge hole to dimensions shown.
-
Measurements in mm
CAUTION!
Washer -7- is only to be riveted to the rear filler panel sheet metal.
-
Using pop-rivets 6, mount washer 7 to under side of filler panel sheet metal.
-
Mount spacer sleeve 4, anchor bracket 3.
-
Install bolt 2.
Tightening torque: 25 Nm (18 ft lb)
-
Install cover 1 onto anchor bracket.
NOTE: Cap 8 is only used to cover hole in rear filler panel trim when anchor bracket is removed or not in use.