A6 Quattro Sedan V6-2.8L (AHA) (1998)
Lower Side Moulding / Trim: Service and Repair
Sill Panel Trim, Removing And Installing
1
-
Sill panel trim holder
-
Removing and installing Fig. 1.
2
-
Screw
-
1 Nm (9 in.lb)
3
-
Self-tapping screw
-
2 Nm (18 in.lb)
4
-
Sill panel trim
-
Remove outer scuff plate before removing.
Removing:
-
Remove screws - 2 -, - 3 - and - 6 - and first pull sill panel trim out from holder - 1 -.
-
Pull forward out of rear trim and remove.
Installing:
-
Install sill panel trim in place on holder - 1 - Fig. 1.
-
Install screws - 3 - from front-to-back.
-
Install screws - 2 - and - 6 -.