A6 Quattro Sedan V6-2.8L (AHA) (1998)
Lock Carrier: Procedures
Lock Carrier, Service Position
Notes:
-
Do not remove noise insulation panel.
-
Loosen front quick-release screws only.
-
Bumper must be removed.
1
-
Lock carrier
For service position:
-
Remove intake air duct between lock carrier and air cleaner housing at lock carrier.
-
On right side, remove bolt - 5 - and install 3369 support tool.
-
On left side, install 3369 support tool into threaded hole Fig. 1.
-
Remove bolts - 2 - on left and right.
-
Remove bolts - 3 - and - 4 - and pull lock carrier - 1 - forward.
-
Secure lock carrier Fig. 2.