A6 Quattro Sedan V6-2.8L (AHA) (1998)
Fluid - A/T: Testing and Inspection
ATF Level, Checking With Auxiliary ATF Cooler
ATF, checking and changing (Automatic Transmission 01V)
ATF level, checking
Special Tools and Equipment
-
VAS5O51 tester with VAS5O51 /1 diagnostic cable (or VAG1551 Scan Tool with VAG1551/3 cable)
-
VAG13O6 drip tray
-
VAG1924 ATF filler tool
-
Protective goggles
Test requirements:
-
Transmission must not be in emergency running mode.
-
Vehicle on level ground.
-
Selector lever in "P", let engine run at idle.
-
NC system and heating switched oft.
-
ATF temperature must not be higher than 30 C at start of test, allow transmission to cool if necessary.
Notes:
-
ATF level changes with ATF temperature.
-
Performing ATF level check when ATF temperature is too high will cause excess filling.
-
Performing ATF level check when ATF temperature is too high will cause insufficient filling.
-
Excess filling and insufficient filling both affect the function of the transmission.
-
An extra ATF check must be performed for vehicles with auxiliary ATF cooler.
-
The ATF temperature is read out by the VA S5051 tester or VAGI551 Scan Tool.
Checking ATF temperature