A6 Quattro Sedan V6-2.8L (AHA) (1998)
/Page-2415004.png)
-
Always replace seal (arrow) for the ATF check plug.
-
Tighten ATF check plug to 80 Nm.
-
Press (arrow) button on VAG1551.
-
Press buttons -0- and -6- to select "End output" and press -Q- button to confirm input.
Additional ATF check for vehicles with auxiliary ATF cooler
This test must be performed after auxiliary ATF cooler has been emptied or when it has been replaced. Installation position of the auxiliary ATF
cooler.
Test requirements:
-
Transmission must not be in emergency running mode.
-
ATF is filled up
-
Selector lever in "P", let engine run at idle.
-
A/C system and heating switched off.
-
The ATF temperature is read out by the VAS5051 tester or VAG 1551 Scan Tool.
Checking ATF temperature
-
Connect VAS5051 tester to vehicle with VAS5051/1 diagnostic wire. Alternately, VAG1551 Scan Tool can also be attached using VAG1551/3
adapter.
-
Start engine.
When indicated on display:
-
Press buttons -O- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.
