A6 Quattro Sedan V6-2.8L (AHA) (1998)
-
Connect multimeter US 1119 (Fluke 83 or equivalent) and check resistance between test box sockets 67 and 69.
Specified value: max. 5.0 Ohms
-
Open throttle slowly.
Specified value: Infinity Ohms
If resistance is NOT OK:
-
Disconnect 8-pin harness connector for throttle valve control module -J338-.
-
Check wiring for open circuit between ECM/test box and 8-pin harness connector.
-
Connector terminal 3 to ECM/test box socket 69
-
Connector terminal 7 to ECM/test box socket 67
-
Specified value: max. 1.5 Ohms
-
Check wiring for short circuit between ECM/test box and 8-pin harness connector.
-
Connector terminal 7 to ECM/test box socket 69
-
Specified value: Infinity Ohms
-
Reconnect throttle valve control module harness connector.
If wiring is OK:
-
Replace throttle valve control module -J338-.
-
Carry out adaptation of throttle valve control module to ECM .
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.