A6 Quattro Sedan V6-2.8L (AHA) (1998)
/Page-7067002.png)
^
95 Nm (70 ft. lbs.)
12. Bolt
^
50 Nm (37 ft. lbs.)
13. Connecting link
^
Installation position: bend faces outward
14. Bolt M12 x 1.5 x 95
^
Always replace
^
70 Nm (52 ft. lbs.) + 1/4-turn (90°)
15. Lower control arm
16. Front bonded rubber mount for lower control arm
^
Pressing out is difficult or impossible. Replace complete control arm if faulty
17. Rear bonded rubber mount for lower control arm
^
Refer to Removing and installing, Fig. 1
18. Drive axle
19. Front bonded rubber mount for upper control arm Removing and installing.
20. Multi point socket-head bolt M8 x 48
^
40 Nm (30 ft. lbs.)
21. Plate
22. Upper control arm
23. Washer
24. Self-locking nut
^
Always replace
25. Rear bonded rubber mount for upper control arm
^
Pressing out and in, Figs. 1 and 2
26. Socket-head bolt
^
95 Nm (70 ft. lbs.)
^
Bottom of bolt head is ribbed
CAUTION: Only this special bolt must be used when replacing. Use only a genuine Audi replacement part.
Special tools, test equipment and auxiliary items
Fig. 1 Pressing hub out of wheel bearing
