A6 Quattro Sedan V6-2.8L (AHA) (1998)
Fig. 6 Pressing wheel hub into wheel bearing with 82 mm
-
When pressing in, pressure piece -VW511- must rest only against bearing inner race.
Installing
-
Tightening torque of spherical cap bolts -1, 80 Nm + turn another 90°.
-
Push outer joint of drive axle into wheel hub and hand-tighten new hex bolt.
Note: Remove any glue remaining on thread of joint bolt.
-
Insert both joint bolts of top control arm into wheel bearing housing.
-
Tighten new self-locking nuts -1- to 40 Nm.
-
Press upper control arm down as far as possible when tightening!
-
Install ABS wheel speed sensor
-
Mount brake disc, screw on brake caliper, and tighten to 190 Nm (M14 x 1.5 x 38).
-
Mount wheel and tighten to 120 Nm.
-
Tighten hex bolt for drive axle.
Tightening Torques:
Hex bolt M14: 115 Nm + turn another 180°.