A6 Quattro Sedan V6-2.8L (AHA) (1998)
/Page-5642002.png)
^
When removing the valve body, only remove the bolts marked with arrows.
^
The bolt identified by arrow -A- is shorter than the other bolts.
^
If any other bolts are loosened, this can affect the function of the valve body.
-
Remove valve body from transmission, together with wiring harness connector.
CAUTION: Do not lay the removed valve body on the sensor for transmission RPM (on the back side of the valve body). Otherwise, there is
risk of damage.
Installing
-
Lubricate new O-rings for connector on wiring harness with ATF
-
Install connector in transmission housing with flat part arrow -A- facing towards oil pan.
-
Align dowel pin on valve body arrow -B- with drilling in transmission housing arrow -C-.
-
Place valve body in position so that pin of detent plate -1- engages in slot on selector slide (manual valve) -2-.
