A6 Quattro Sedan V6-3.0L (AVK) (2002)
-
Pull wire - 6 - through to the inside together with connector - 9 -.
Installing
-
Make sure that wire - 6 - is not trapped.
4
-
Release catch for lift mechanism
Removing
-
Use a screwdriver to pry out release catch - 4 - at the top.
-
Press out release catch - 4 - at the bottom.
Installing
-
Insert at the bottom first.
5
-
Bolts (4x)
-
Before removing, warm bolts - 5 - using a soldering iron until smoke rises and then loosen the bolts with a jolt.
-
Always replace.
-
Before installing new bolts, clean out threads in threaded inserts (re-tap).
-
Tightening torque: 2 Nm (18 in.lb)
6
-
Wire
7
-
Mount
8
-
Mount
9
-
Connector
Side hinge trim, removing