A6 Quattro Sedan V6-3.0L (AVK) (2002)
CAUTION: Always adhere to B-pillar trim installation sequence.
Installing
-
Insert trim - 1 - with retaining clips - 10 - in lower B-pillar trim - 9 -.
-
Guide seatbelt height adjuster switch - 12 - into height adjuster assembly - 8 - Fig. 1.
NOTE: Do not press switch - 4 - when installing.
-
Carefully press airbag module - 5 - upward.
-
Slide B-pillar trim up under airbag module - 5 -.
-
Be sure not to damage airbag module with tools when installing.
-
Install bolts - 2 -.
-
Remove bolts - 4 - at bracket, on left and right of B-pillar.
-
Rest of installation is reverse of removal.
-
After assembling trim, make sure seal is properly installed
NOTE: Function check after installing trim:
-
Height adjuster must audibly engage into all five possible positions (even top position).
-
Button must return by itself to upper position after being actuated.
2
-
Bolt
-
Tightening torque: 3.5 Nm (31 in lb)
-
Self-locking
-
Always replace