A6 Quattro Sedan V6-3.0L (AVK) (2002)
/Page-1533005.png)
-
Disconnect harness connector -1- of electrical wire to clutch for A/C compressor.
-
Unbolt A/C compressor from bracket (arrows).
-
Hang A/C compressor (with refrigerant lines attached) to stabilizer using wire.
-
Unbolt angle bracket for wiring harness from left engine mount.
-
Mark installation positions of threaded connections -1- and positioning sleeves -2- below on engine mounts at right and left.
Note: Different mounting bores are available depending upon the installed engine.
-
Remove nuts 1 at bottom on left and right engine mounts.
