A6 Quattro Sedan V6-3.0L (AVK) (2002)
Transmission Position Switch/Sensor: Service and Repair
Multi-Function Transmission Range (TR) Switch -F125- A/T 01V
Removing
-
Remove left transmission support.
-
Remove Multi-Function TR Switch -F125 at transmission and pull off at selector shaft.
Installing
-
Install Multi-Function TR Switch -F125 onto selector shaft. Flat on splines in switch -3- must be positioned on flat of selector shaft -1-.
Note: Center Multi-Function TO Switch -F125- on the selector shaft. Do not twist and do not use any force to install the switch. Damage to the
contacts may result if the switch is mishandled.
-
Turn switch until installation hole-4 on switch housing can be inserted onto dowel pin -2- of transmission housing.
-
Install left transmission support.
Tightening torques
Multi-Function TR Switch -F125- to transmission 8 Nm (70 inch lbs.)