A6 Quattro Sedan V6-3.0L (AVK) (2002)
-
This screen comes up and shows the percentage of progress for "Update - Programming"
-
If, during the "Update - Programming", a fault message is displayed, the control unit could be damaged and cannot be flashed:
-
Confirm that the VAS 5051 or VAS 5052 diagnostic tool power supply is adequate and that all appliances with high electromagnetic radiation
(i.e. mobile telephones) are switched OFF
-
The "Update - Programming" process must then be started from the beginning using the "Repeat" button -arrow-
IMPORTANT: Under no circumstance should the "Cancel" button be selected.
-
This screen comes up when "Update - Programming" is complete
NOTE: The old software level is still displayed -arrows-. The new software level is not displayed until the process is complete and fault
memories have been erased.
-
Select "Print" then select "Screen"
-
The VAS 5051 will print to printer immediately
-
The VAS 5052 will hold the print until the process is complete and then you may take the tester to the printer for printing the screen
-
Attach a copy of the print to the repair order
-
Select the (>) right arrow continue button -arrow 2-