A6 Quattro Sedan V6-3.0L (AVK) (2002)
Removing
-
Shift selector lever to "2".
-
Obtain radio antitheft code.
-
Disconnect battery ground connection.
-
Remove handle for selector lever.
-
Remove front center console.
-
Remove steering wheel.
-
Turn ignition key to driving position (ignition on).
-
Shift selector lever to "P".
-
Lift clip for retainer -1-and pull out lock cable from ignition/starter switch.
-
Remove cover with gate (selector lever actuation).
-
Unclip lock cable from securing spring at mounting bracket while slightly lifting securing spring.
-
Free lock cable from cable tie -2- and remove.
Installing
-
Route lock cable without kinks.
-
Turn ignition key to driving position (ignition on).
-
Insert lock cable in ignition/starter switch.
-
Check locking device -1- for proper engagement.
-
Attach lock cable with cable tie -2-to airbag sensor.
-
Turn ignition/starter key to lock position (ignition off).
-
Shift selector lever to "P".
-
Clip in lock cable in securing spring of mounting bracket.
-
Insert Lock cable bracket -3- in shift mechanism and lock cable eye in lever for lock cable.
Adjusting
-
Shift selector lever to "P".
-
Loosen bolt -6
-
Clamp -3- must be movable by hand in direction of arrow -5-.
-
Move steering column to lowest position.
-
Insert gage 3352 A item 4 between lever for lock cable and lock cable eye.
-
Pull lock cable in direction of arrow -5- and tighten bolt -6- with 10 Nm (7 ft. lbs.).
-
Remove adjustment gage.
-
Check ignition key removal lock after every adjustment of the lock cable.
-
Install steering wheel.
-
Install front center console
-
Install handle for selector lever
-
Reconnect battery ground cable.
-
For vehicles with theft protected radio reactivate code.