A6 Quattro Sedan V6-3.0L (AVK) (2002)
/Page-2919003.png)
^
The bolt (arrow -At is shorter than the other bolts. Observe allocation.
All
-
Remove valve body from transmission while guiding wiring harness connector.
Note for transmissions with hydraulic control E17:
Do not set removed valve body on sensor for transmission RPM at rear of valve body. Risk of damage.
Installing
-
Lightly coat O-ring of wiring harness connector with ATF.
-
Insert wiring harness connector into transmission housing.
^
Installation position: Flat part of rear shoulder points downward, the tabs at shoulder are horizontal.
Only for transmissions with hydraulic control E18/2
-
Route wire with connector-C- according to illustration so that the wiring is not pinched during installation of the valve body.
All
