A6 Quattro Sedan V6-3.0L (AVK) (2002)
Flex Plate: Service and Repair
Drive plate for automatic transmission 01V:
Removing
Transmission removed
WARNING: Turning of the engine must only occur in direction of engine rotation (clockwise) at the crankshaft.
-
Turn crankshaft via central bolt of toothed belt gear in direction of engine rotation to TDC Cyl. 3 marking.
^
Notch -1- is opposite marking -2
-
If installed, disconnect electrical harness connector at after-run coolant pump.
-
Unscrew sealing plug of TDC mark at cylinder block.
-
Thread T40026 locking pin into the hole of the removed sealing plug and tighten.
Note: Slightly turn crankshaft back and forth to do so.
-
Mark drive plate to engine.
-
Remove drive plate.
Installing
Installation is reverse of removal, noting the following: