A6 Quattro Sedan V6-3.0L (AVK) (2002)
Flywheel: Service and Repair
Flywheel or Drive Plate, Removing and Installing
Flywheel or drive plate, removing and installing
Special Tools and Equipment
^
T40026 locking pin
Dual-mass flywheel or flywheel for automatic transmission 01J
Removing
Transmission removed
WARNING: Turning of the engine must only occur in direction of engine rotation (clockwise) at the crankshaft
-
Turn crankshaft via central bolt of toothed belt gear in direction of engine rotation to TDC Cyl. 3 marking.
^
Notch -1- is opposite marking -2
-
If installed, disconnect electrical harness connector at after-run coolant pump.
-
Unscrew sealing plug of TDC mark at cylinder block.
-
Thread T40026 locking pin into the hole of the removed sealing plug and tighten.
Note: Slightly turn crankshaft back and forth to do so.