A6 Quattro Sedan V6-3.0L (AVK) (2002)
/Page-2977005.png)
-
Drive flange for drive shaft far enough onto drive pinion so that securing nut can be installed.
-
Clean drive pinion nut and thread at drive pinion from oil and grease residue. Lightly coat thread with locking fluid D 000 600.
Note: Use existing hex nut for securing flange to drive pinion. Otherwise the original installation position will not be found again.
-
Tighten drive pinion exactly to the previously marked position.
-
To ensure that the installation is OK, perform a check measurement of measurement -a- and -b
^
Max. deviation from original measurement: + 0.5 mm
-
Secure hex nut.
-
Top off transmission fluid in rear final drive and check oil level.
-
Determine radial run-out at flange/drive shaft if a factory marking (color marking) is present at the drive shaft, and align color marking on drive
shaft to new marking on flange.
-
If there was no factory marking on drive shaft (color marking) and therefore the position of the drive shaft in relation to the final drive flange was
