A6 Quattro Sedan V6-3.2L (BKH) (2005)
Collision Avoidance Warning Indicator: Service and Repair
Hazard Alarm Control Module, A6
Hazard Alarm Control Module, A6
Removing
-
Open the flap and remove the screws - arrows -.
-
Remove the Com box - 1 - from the luggage compartment.
-
Remove luggage compartment left side trim..
-
Remove the bracket for the control modules. Refer to => Communication 91 Removal and Installation.
‹› Electrical connectors remain connected.
CAUTION!
The hazard alarm control module will be destroyed if its connectors are disconnected while the battery is connected.
-
With ignition switched off, disconnect battery Ground (GND) wire. Refer to=> Battery, Starter, Generator, Cruise Control 27 Removal and
Installation.
-
Mark the wires - 1, 4 and 5 -.
-
Disconnect the wires - 1 through 5 -.