audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Instruments - Fuel Gauge Not Showing Full After Fill Up|Page 22362 > < Instruments - Fuel Gauge Not Showing Full After Fill Up|Page 22360
Page 1
background image

Instrument Panel Control Module: Customer Interest
Software Version Management (SVM) Operating Instructions

00 Software Version Management (SVM), Operating Instructions

01 08 33 

2011732/6 

December 15, 2008

Supersedes Technical Service Bulletin Group 01 number 08-06 dated November 17, 2008 for reasons listed below.

Vehicle Information

Condition

This Technical Service Bulletin details the general process for carrying out a Software Version Management (SVM) software update for any TSB/RVU.
Troubleshooting information is included in the Additional Information section.

Technical Background

SVM is a process to update the programming in flashable (re-programmable) control modules and/or to document changes in software levels in Audi
vehicles. This system uses the VAS 5051B or VAS 5052 diagnostic tools to send vehicle-specific data to the SVM database, to download instructions
from the SVM database, and to flash control units for identified software updates.

The technician must first diagnose the condition in the vehicle and find a Technical Service Bulletin that describes that condition. This conditional
bulletin specifies the appropriate action code for the programming update to be carried out immediately. SVM eliminates the need to wait for Flash CDs
to be sent to the dealer and eliminates problems such as scratched or missing discs. This allows the updates to be performed faster and more efficiently at
the dealership.

Production Solution

Not applicable.

Service

1. If you encounter a vehicle with a tuned ECM or TCM, your dealership must do the following before performing any procedure that updates ECM

or TCM programming:

NOTE:  

Any Update Programming procedure (flash) may overwrite any tuned ECM or TCM programming. A tuned ECM or TCM is described as any
ECM or TCM altered so as to perform outside the normal parameters and specifications approved by Audi of America, Inc.

a. Notify the owner that their ECM or TCM was found to have been tuned.

b. Notify the owner that any damage caused by the tuning of the ECM or TCM (including any adverse emissions consequences) will not be

covered by Audi of America, Inc. warranties.

Instruments - Fuel Gauge Not Showing Full After Fill Up|Page 22362 > < Instruments - Fuel Gauge Not Showing Full After Fill Up|Page 22360