A6 Quattro Sedan V6-3.2L (BKH) (2005)
Tire Pressure Module: Service and Repair
Tire Pressure Monitoring Control Module 2
Tire Pressure Monitoring Control Module 2
Removing
The tire pressure monitoring control module 2 (J793) is located under the glove compartment.
Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.
-
Remove glove compartment.
-
Unclip control module - 1 -.
-
Disconnect connector - 2 - and remove control module.
-
Remove tire pressure monitoring control module 2 (J793) - 1 - and disconnect the connector - 1 -.
Installing
Installation is in reverse of removal, with special attention to the following:
-
If Tire Pressure Monitoring Control Module 2 (J793) is replaced, system must be recoded.
-
Connect the VAS 5051 and select the control module in "Guided Functions"