A6 Quattro Sedan V6-3.2L (BKH) (2005)
/Page-5679001.png)
Seat Occupant Sensor: Removal and Replacement
Passive Occupant Detection System
Passive Occupant Detection System
CAUTION!
Observe the safety precautions for repairs on airbags.
CAUTION!
Replacement part (service kit) for seat occupied sensor is already pre-calibrated and must not be disconnected under any circumstance.
The service kit consists of:
‹› Seat Occupied Recognition Control Module (J706)
‹› Seat Occupied Recognition Pressure Sensor (G452)
‹› Passive Occupant Detection System Mat
‹› Seat cushion
‹› Wiring harness between Seat Occupied Recognition Control Module (J706) and Seat Occupied Recognition Pressure Sensor (G452)
‹› The passive occupant detection system is only installed on the front passenger seat.
1
Seat Occupied Recognition Control Module (J706)
Removing
-
Disconnect the battery ground (GND) strap.
