A6 Quattro Sedan V6-3.2L (BKH) (2005)
-
Replace the Engine Control Module (ECM) (J623). Refer to=> [ Engine Control Module, Replacing ] See: Powertrain Management/Computers
and Control Systems/Engine Control Module/Service and Repair/Engine Control Module, Replacing
-
Assembly is performed in the reverse of the removal.
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.